Showing all 32 results
The biggest disadvantage of monolithic capacitors is the high temperature coefficient, and the stability of the oscillator is unbearable.
Electrolytic Capacitor is a polarized capacitor whose anode or positive plate is made of a metal that forms an insulating oxide layer through anodization.
This capacitive touch sensor module uses the TTP229 integrated circuit, making it easy to add capacitive touch input to your project. It features 16 sensitive touch pads that make an ideal replacement for the old fashioned keypads.
Zener diode works like a normal diode in the FORWARD direction, but when voltage is applied in the REVERSE direction it does something really useful.
Polyester film capacitors are film capacitors using a dielectric made of the thermoplastic polar polymer material polyethylene terephthalate.
Blue 5MM is a very basic 5mm LED with a blue lens. It has a typical forward voltage of 3.4V and a rated forward current of 30mA.
Inductor is a passive component that is used in most power electronic circuits to store energy in the form of magnetic energy when electricity is applied to it.
Brushless ESC is specifically made for quadcopters and multi-rotors and provides faster and better motor speed control giving better flight performance compared to other available ESCs.
CD4512 is a part of the CD4000 IC series. The CD4512 IC is an 8-channel data selector. The IC circuitry is housed within a CMOS circuit constructed using N and P – channel transistors.
Crystal Oscillator is an Electronics Oscillator circuit which uses the mechanical resonance of a vibrating crystal of piezoelectric material to generate an electrical signal with an accurate frequency.
Its essential component is a metal wire or strip that melts when too much current flows through it, thereby stopping or interrupting the current.
This DC Motor is very micro, compact and lightweight then this DC motor can save electricity to a great extend. Environmental protection is the another inevitable feature of this DC motor.
12VDC1/2″ElectricSolenoid Water is an electromechanically device used for controlling liquid or gas flow.
Jumper wires Female to Female is an electrical wire or a group of them in cable with a connector or pin at each other.
L293D is a typical motor driver or motor driver IC which allows DC motor to drive on either direction.
Line tracking & IR control & obstacle avoidance is flexible vehicle kit which support IR remote control and mobile app control.
MCP73833 Evaluation Board is an evaluation and demonstration tool for Microchip’s MCP73833/4 Stand-Alone Linear Li-Ion/Li-Polymer Charge Management Controllers.
Micro SD Card Module is used for transferring data to and from standard sd card.the pin out is directly compatible with arduino and also can be used with other microcontrollers ,then it allow us to add mass storage and data logging to project.
DIY Prototype Paper PCB is widely used to embed the circuit randomly for running hardware.
This is the antenna for GSM Modems. A small, high-quality, quad-band, standard SMA terminated, cellular antenna. Has a length of 2 inches.
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element
Resistors is a passive two terminal electrical component that implements electrical resistance as a circuit element.
This sensor is in dormant state when in lighting environment, for example in daytime.
Can be controlled by any sound and it will working In the dark environment, for example in night.
TDA7377 is a class AB car radio amplifier for car radio, it can work either in dual bridge or quad single ended configuration
TIP120 is a NPN Darlington Power Transistor. It can switch loads up to 60V with a peak current of 8A and continuous current of 5A.
The audio pre-amplification means for getting output audio with low noise, interference, distortion and also used for controlling the volume, bass and treble.
The USB Virtual 7.1 channel sound adapter is a higher flexible audio interface which can be either desktop or Notebook system.