Single 1 Channel 5v Relay Module
$2.07
This module acts as a bridge between low-voltage digital signals and high-voltage devices, allowing safe control of AC or DC equipment.
$2.07
This module acts as a bridge between low-voltage digital signals and high-voltage devices, allowing safe control of AC or DC equipment.
 Perfect for:
-
Home automation
-
DIY electronics
-
Smart control systems
Description:
100% brand new and high quality
1-Channel relay module, with photoelectric isolation
The module can be high or low by a jumper setting trigger
With power and relay action indicator
The module Operating voltage 12V
The module uses genuine quality relay, normally open interfaces
Maximum load: AC 250V/10A, DC 30V/10A
| Pin Name | Function |
|---|---|
| VCC | Connect to 5V power (e.g., from Arduino) |
| GND | Ground (shared with microcontroller) |
| IN | Signal pin (LOW triggers the relay) |
Relay Output Terminals (High Voltage Side)
| Terminal | Description |
|---|---|
| COM | Common – connected to power or ground of load |
| NO | Normally Open – connected to COM when ON |
| NC | Normally Closed – connected to COM when OFF |
How It Works
-
Send a LOW signal to
IN→ relay turns ON (NO connects to COM) -
Send a HIGH signal to
IN→ relay turns OFF (NO is open)
Sample Arduino Code
int relayPin = 7; // Connect to IN pin
void setup() {
pinMode(relayPin, OUTPUT);
digitalWrite(relayPin, HIGH); // Relay OFF at start
}
void loop() {
digitalWrite(relayPin, LOW); // Relay ON
delay(1000);
digitalWrite(relayPin, HIGH); // Relay OFF
delay(1000);
}
If you’re using ESP32 (3.3V logic), make sure the relay module supports 3.3V input or use a level shifter/transistor.
Safety Tips
-
âš¡ High voltage kills! Never touch relay terminals while powered.
-
Use proper insulation and secure wiring.
-
Use a flyback diode if switching motors or inductive loads (for DC only).
-
Make sure load current does not exceed relay specs (10A max).
Module interface:
DC+: positive power supply (VCC)
DC-: negative power supply (GND)
IN: The control end, the driving current should be more than 4mA
COM: The control of loop of earth wire
Features :
- Brand Name:Â WAVGAT
- Condition:Â New
- Type:Â Relay Module
- Supply Voltage:Â 5V 12V
- Package:Â module
- is_customized:Â Yes
- Dissipation Power:Â ..
- Model Number:Â 5V low level trigger One 1 Channel Relay Module
- Application:Â Relay Module
- Operating Temperature:Â -40-+85
if you want to know how to use it, watch this video can be help for you.
 Specifications :
| Parameter | Value / Range |
|---|---|
| Input Voltage | 5V DC (for relay coil & control) |
| Control Logic | Active LOW (LOW = ON) |
| Control Pin | IN (from MCU GPIO) |
| Load Voltage | AC: 100–250V / DC: 0–30V |
| Load Current | Up to 10A |
| Relay Type | SPDT (Single Pole Double Throw) |
| Isolation | Optocoupler between input/output |
| Indicator LED | Shows when the relay is active |
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.






There are no reviews yet.