The DC 12V 10A Adjustable Time Delay Relay is a versatile multi-function timer module used for home automation, industrial control, and DIY projects. It features 32 programmable modes and can handle loads up to 10A.
Core Specifications:
-
- Operating Voltage: Available in 12V DC versions.
- Load Capacity: Supports DC 30V/10A or AC 250V/5A.
- Timing Range: Adjustable from 0.1 seconds to 999 minutes (or up to 10 days in some versions).
- Accuracy: Timing precision down to 0.01 seconds.
Programming Instructions
Most models use a four-button interface (K1-K4 or Set, Swi, +, –).
-
- Enter Setup: Press and hold K1 (SET) for ~2–3 seconds until the display flashes (e.g., “P-11”).
- Select Mode: Use K2 to cycle through the main modes (P1-P4) and K3/K4 to pick a specific sub-mode (e.g., P-11 to P-48).
- Set Time (A & B):
-
- Short press K1 again to set Time A (e.g., “A001”). Use K2/K3 to change the number.
- Press K4 to move the decimal point, which changes the time unit:
-
XXX: Seconds (1–999)XX.X: 0.1 Seconds (0.1–99.9)X.X.X: Minutes (1–999)
-
-
- Save: Long press K1 to exit and save settings.
Common Operating Modes
- P1.1 (Triggered Delay): When triggered, the relay turns ON for time A, then stays OFF.
- P2.1 (Delayed Start): When triggered, the relay stays OFF for time A, then turns ON for time B, then stays OFF.
- P3.1 (Infinite Cycle): After a trigger (or power-on), the relay cycles ON for time A and OFF for time B indefinitely.
- P4 (Signal Hold): The relay stays ON as long as there is a trigger signal. When the signal disappears, it remains ON for time A before turning OFF
Wiring Diagram Guide
- Power Input: Connect DC+ and DC- to your power source.
- Trigger: Connect the signal source to IN+ and IN-.
- Relay Output (Dry Contacts):
- COM (Common): Power input for the load.
- NO (Normally Open): Connect to the load for “Delay ON” or “Timed ON” behavior.
- NC (Normally Closed): Connect here if the load should be ON by default and turn OFF during the delay.
DC Time Delay Relay Module
Maximum current the relay can handle
- Can control devices up to 10 Amps
- Works with DC or AC loads
Adjustable Time Delay
You can set time:
- From 0.01 seconds up to hours
Different behaviors:
- Delay ON
- Delay OFF
- Pulse
- Cycle (repeat ON/OFF)
- Trigger-based control
LED Digital Timing
Built-in display:
- Shows time
- Shows mode (P1–P32)
Trigger Control
Starts when:
- Button is pressed
- Signal is applied to IN pin
Pulse / Cycle
Special functions:
- Pulse → ON for short time
- Cycle → ON/OFF repeatedly
How it works (simple)
- Power the module
- Select a mode (P1–P32)
- Set time
- Trigger it
- Relay switches your device
Example use
- Light turns ON after delay
- Water pump runs for 10 seconds
- Motor cycles ON/OFF automatically
Important
- Use correct voltage (12V )
- Don’t exceed 10A load
- Be careful with high voltage
Package include:
- DC 12V 10A Adjustable Time Delay Relay Module







There are no reviews yet.